The information prefilled in the ‘Configure Miniserver’ window is only the default information, and needs to be replaced according to your network settings.
LOXONE SERVER SOFTWARE
This could be caused by antivirus software or a firewall blocking the command or the connection from the device to the Miniserver being poor. If this doesn’t happen the Miniserver hasn’t rebooted and the command hasn’t been sent. A successful command will cause the status LEDs on the Miniserver to go orange briefly. The Miniserver will reboot as soon as you send the new network information. If it has been longer than 1 hour then simply power cycle (Turn off and On) the Miniserver. Note that you can only send network changes to a Miniserver with 1 hour of powering it up. Your Miniserver has now been assigned the new IP address. Enter the desired IP address, Subnet, Default Gateway, DNS servers and click Send. To manually set an IP address, Select “Use Static IP Address”. If this does not allow you to connect please contact our technical support.įirst, select ‘Configure Miniserver’ in the title bar, within the Miniserver tab.Įnter the MAC address (serial number) of your Miniserver. If you are still have difficulties try disabling the anti-virus program completely. If you have connection problems check that Loxone Config has been allowed through the firewall and the anti-virus program. Network connections are often blocked by firewalls or anti-virus programs. There you can set major setting just like Network Config and project address.Īfterwards you can see in the status bar that you are connected. If you run your Miniserver the first time you can also do the Initial Setup.
LOXONE SERVER PASSWORD
Highlight the Miniserver in the Search results and enter the username and password (the default is ‘admin’ for both).
LOXONE SERVER SERIAL NUMBER
The Miniserver will be listed in the Search results window with the name, IP address, serial number and firmware version. Click on this and the whole network is searched to find the Miniserver.
Open Loxone Config and in the tab Miniserver find the Search button. It is important that your Miniserver is connected to the same network as your computer so you can use the Miniserver Search in Loxone Config. The Miniserver will now get an IP address automatically from the router (DHCP server). The Miniserver will then boot from the inserted MicroSD card which stores all the firmware and user data.
When connecting for the first time, connect the network adaptor to the network then connect the power supply. * Optional steps depending on configuration and requirements CONNECT TO THE MINISERVER Wait until the left hand LED on the Miniserver flashes constantly and steadily (approx 2Hz)
Terminate the Loxone Link at the last extension with 120Ω resistor* Connect 24V DC power supply, but do not switch on until the whole installation is completeĬonnect Miniserver to extensions via Loxone Link*
0 kommentar(er)
